Item #: TN-100
Availability: Available
Usually ships In 24 hours (not including weekends)

ON SPECIAL!!!

Retail: $224.00
Price: $197.95
You Save: $26.05 (11.6%)

    Quantity:
    • TN-100 Tubing Notcher - TN-100
    • TN-100 Tubing Notcher - TN-100
    Large Capacity and Low Cost- The TN-100 notches 3/4" through 2" O.D. tubing at angles up to 50 degrees in under 20 seconds. It uses commonly available bimetal hole saws. A single bimetal hole saw will typically notch 3 to 5 complete cars

    Easy To Use- The TN-100 may be mounted in a drill press or simply clamped in a vise and used with a 1/2" hand drill. The 1/2" hand drill setup is by far the best in our opinion. In this way the TN-100 can be laid horizontal and when notching 45 degree angles the floor will not interfere with the tubing being notched. Also, since the hand drill is fed in horizontally, the drill's weight doesn't try to force the hole saw in too fast.

    Heavy Duty Frame-Entirely CNC machined, the frame is made from 1/2" thick 6061-T6 and its face has been milled flat. The degree increments are then machined directly into the frame. An all position swivel insures an easy setup.

    Rigid Bearing Block- This is the most critical part of a hole saw style notcher. The TN-100's bearing block uses twin needle bearings and separate grease seals for maximum rigidity and reliability. We could of used the cheaper bronze bushings, but then you'd be replacing them every job and cussing us too.
    Strong, Accurate Tube Cradle- As can be seen in the picture, the entire cradle assembly has been designed to be tough, accurate and easy to use. By CNC machining the cradle out of a solid steel block we know the tube will be notched in the exact middle. Plasma cut and welded cradles can't come close to the accuracy of the TN-100. The clamp mechanism rides in its own guide ad has also been machined from a solid block of steel. This eliminates the problems of tube walk in notchers that use a U-strap.

    Does not come with holesaws, you can order them here